Not interested in C and the second one is done through terminal not through code. If i remember correctly i recall reading about the DHT22 outputting bits, maybe i can convert those to bytes and then the 0's and 1's into readable data? I'll try what i mentioned in a bit or maybe tomorrow and ill update for other peopleProper timing needed by the sensor via GPIO pins. If gpiozero cannot do it, then the C libraries can. Python can use libraries written in C, but someone has to write those.
Again, you're depending on someone else writing code that you can use.
Perhaps you can use C instead?
Or maybe use a Pi 4 or Pi 0 for your project, those libraries should still work on those.
Or you can see if the dtoverlays can help: viewtopic.php?t=366269
Statistics: Posted by scel5525pro2 — Thu Aug 08, 2024 7:54 pm