Chances are high that you can say 'RIP poor little display and controller board' as you've - most likely - reversed some voltages ('the back started heat')...
Now I have compared the charts of the pinout of the 40 pin video connector of the screen i have and the 4tn chart at the last chart. The only differences I realized was some NC (No connect) pins with some GND pins.
Thinking this isn't a really big problem, I plugged the screen everyway I can, and it always resulted with a blank screen. Then, I tried to have a strong flshlight between my screen, and it was still blank (with some light coming behind. Then, for once, there were some lines, and some dots in some squares (btw the squares don't really exist, but if you imagine the dots are centered with some equal squares compressed to each other, it is going to be easier to understand the dots' shapes) and when was this happening, the back started heat. I plugges the cable off, when i tried it back, there was nothing. Also the shapes I mentioned was only at the left side of the panel. Now I dont know what to do, please help...
..
Statistics: Posted by aBUGSworstnightmare — Fri Sep 13, 2024 6:25 am