Beginners • Re: Connect a RPI Zero 2W to a composite connector?

You did not connect GND as well?

Got ground from another pad and adding that to the RCA connector sleeve didn't make any difference; the signal was the same with or without ground, so I thought it didn't make any difference

Yes, you'll need ground. The config settings look right. You'll need to Google for common faults and fixes.

Thanks, at least knowing I did everything as expected is a good start.

Is it normal that after boot, if I plug in HDMI I see the output but in low resolution on my HDMI monitor? I thought that when you boot in composite mode the HDMI should be disabled.

Statistics: Posted by raspnoobie — Mon Dec 23, 2024 1:22 am

---