General discussion • Re: how to boot from m.2

dear all
i just bought raspberry pi compute module 5 and Compute Module 5 IO Board and i install Samsung 990 PRO 1TB with Heatsink NVMe Gen 4 M.2 Internal SSD
now the challenge is how to boot from NVMe ?
thanks
with regards

I can't tell you what the "approved" method is, but what I did was to build a bootable SD card, boot from that, then run the rpi-imager targetting the NVMe SSD. Once that was done, shut down the Pi. Remove the SD card. Boot the Pi from the SSD. The SD card can then be used to set up other Pis the same way if you're dealing with more than one.

Statistics: Posted by W. H. Heydt — Thu Dec 26, 2024 12:18 am

---