good evening everyone,
ive just picked up v1.0 pi400 4gb to hopefully use as an upgrade to a pi3 project i have in use, but in order to do this i need to be able to power up the 400 from gpio. i cannot seem to get this to work at all.
i have updated the eeprom bootloader and enabled wake_on_gpio but it still will not turn on.
i do not plan to have the keyboard attached once device is in situ and i am no good at soldering so i would rather like to avoid that route if possible.
any ideas what i am doing wrong here ?
ive just picked up v1.0 pi400 4gb to hopefully use as an upgrade to a pi3 project i have in use, but in order to do this i need to be able to power up the 400 from gpio. i cannot seem to get this to work at all.
i have updated the eeprom bootloader and enabled wake_on_gpio but it still will not turn on.
i do not plan to have the keyboard attached once device is in situ and i am no good at soldering so i would rather like to avoid that route if possible.
any ideas what i am doing wrong here ?
Statistics: Posted by dmpdiscos — Sun Apr 06, 2025 8:52 pm