Hello!
I'm posting here because I need some advice/help.
After a couple hours of research (searching the forums and reading Jeff Geerling's post below), it seems that the RPi5 does support PTP.
https://www.jeffgeerling.com/blog/2022/ ... rry-pi-cm4
I'm looking to use three RPi5s for PTP, where one is the grand master and the others are slaves.
Has anyone tried this? If so, any pointers, instructions or projects you can point me to would be greatly appreciated. I searched the forum a bit but nothing stood out.
Also, could someone with an RPI5 run the following command and post the output? I don't have access to an RPi5 yet.
Thanks in advance; I appreciate the guidance.
Phil
I'm posting here because I need some advice/help.
After a couple hours of research (searching the forums and reading Jeff Geerling's post below), it seems that the RPi5 does support PTP.
https://www.jeffgeerling.com/blog/2022/ ... rry-pi-cm4
I'm looking to use three RPi5s for PTP, where one is the grand master and the others are slaves.
Has anyone tried this? If so, any pointers, instructions or projects you can point me to would be greatly appreciated. I searched the forum a bit but nothing stood out.
Also, could someone with an RPI5 run the following command and post the output? I don't have access to an RPi5 yet.
Code:
ethtool -T eth0Phil
Statistics: Posted by PhilJoe — Tue Apr 08, 2025 9:36 pm