I saw the following passage in the data manual:
How should I understand this? Do the CSI and DSI share pins? If I want to use DSI0, do I need to turn off CSI0?"2.11. MIPI Interface connectors (22-pin 0.5mm pitch cable)
There are two 4-lane MIPI DSI/CSI-2 connectors. CAM/DISP 0 supports both displays or cameras. CAM/DISP 0 supports using a signal to power down the camera to save power. CAM/DISP 1 typically needs two jumpers fitting to J6 to route the I2C signals from the GPIO connector to the camera connector. CAM/DISP 1 can be used with displays and cameras. If it is used with a camera, it isn’t possible to power down the camera."
Statistics: Posted by xuel — Mon Apr 28, 2025 1:50 am