Hello everyone,
I am using the RP2040 microcontroller for energy management in passenger vehicles. The device runs inside the vehicle and generally works well. However, occasionally the RP2040 gets stuck (freezes) and stops responding.
The problem is that even though the power remains supplied, the RP2040 does not continue to operate unless I completely cut off the power and then restore it. This issue happens rarely, but when it does, I cannot recover the device without a hard power reset.
Has anyone experienced similar behavior or have ideas on what might cause this? I’m sharing the power schematic in the attachment for reference.
Thanks in advance for your help!
Energy Schematic =
![Image]()
I am using the RP2040 microcontroller for energy management in passenger vehicles. The device runs inside the vehicle and generally works well. However, occasionally the RP2040 gets stuck (freezes) and stops responding.
The problem is that even though the power remains supplied, the RP2040 does not continue to operate unless I completely cut off the power and then restore it. This issue happens rarely, but when it does, I cannot recover the device without a hard power reset.
Has anyone experienced similar behavior or have ideas on what might cause this? I’m sharing the power schematic in the attachment for reference.
Thanks in advance for your help!
Energy Schematic =
Statistics: Posted by WaziRiPi — Fri May 23, 2025 7:27 am