PINN has been updated to v3.8.8
V3.8.8
If you want to upgrade your installations for use on a Pi5 at a later date, then this is a mandatory upgrade.
The first Pi5 supported version of PINN will hopefully just fit into an existing 64MB partition, but to allow for future enhancements, the PINN recovery partition is being increased to 128MB.
So if you are thinking of upgrading to Pi5, it is suggested to do a fresh PINN installation to ensure your recovery partition is expanded tp the correct size as early as possible.
This can also be done by setting the `runinstaller` option in the configuration, but be aware that this will wipe out any installed OSes, just like doing a new fresh install.
Support for a separate swap partition has been included in the Utility category.
Some initial display messages were not being translated, so this is now fixed.
V3.8.8
- Translations - Fixed translation of initial messages.
- Self-Update - upgraded implementation in preparation for Pi5
- Partition size - Updated to 128MB
- mkswap - Added support for an additional swap partition
If you want to upgrade your installations for use on a Pi5 at a later date, then this is a mandatory upgrade.
The first Pi5 supported version of PINN will hopefully just fit into an existing 64MB partition, but to allow for future enhancements, the PINN recovery partition is being increased to 128MB.
So if you are thinking of upgrading to Pi5, it is suggested to do a fresh PINN installation to ensure your recovery partition is expanded tp the correct size as early as possible.
This can also be done by setting the `runinstaller` option in the configuration, but be aware that this will wipe out any installed OSes, just like doing a new fresh install.
Support for a separate swap partition has been included in the Utility category.
Some initial display messages were not being translated, so this is now fixed.
Statistics: Posted by procount — Sun Apr 07, 2024 9:47 pm