Apologies for the confusion.
is it possible to increase Pi4B PLO11 uarts to 32Mbaud??
Probably this one: https://github.com/raspberrypi/pico-exa ... analyser.c
Yes, I would like to overclock at least 666Mhz to give 1.5ns sample time or faster would be better. To measure
propagation delay and rise time.
I was just seeing if guys that have experience in this area, think it might work, dropping the work load off the RP2350 and allow on chip voltage regulator to get above 2.2 volts while sampling GPIOs thru PIO-DMA-MEM.
The datasheet is easy but I'm new to Cmake, SDK ect. examples are very helpful and I can't see any WFI examples.
thanks Brian
is it possible to increase Pi4B PLO11 uarts to 32Mbaud??
Probably this one: https://github.com/raspberrypi/pico-exa ... analyser.c
Yes, I would like to overclock at least 666Mhz to give 1.5ns sample time or faster would be better. To measure
propagation delay and rise time.
I was just seeing if guys that have experience in this area, think it might work, dropping the work load off the RP2350 and allow on chip voltage regulator to get above 2.2 volts while sampling GPIOs thru PIO-DMA-MEM.
The datasheet is easy but I'm new to Cmake, SDK ect. examples are very helpful and I can't see any WFI examples.
thanks Brian
Statistics: Posted by brianWS — Tue May 06, 2025 3:29 am