Hi,
I have a CM5 + IO Board and am trying to get serial access using a Debug Probe.
The Debug Probe, connector U, is connected to the 40 pin header as show.
[ ... ]
But I see no output or login prompt when I boot the PI.
What might I have missed?
"What might I have missed?"
I think I am correct in saying that the default console for a CM5 module is routed to unconnected test pads on the module, not to the 2x20-way header on the accompanying CM5 IO Board.
Statistics: Posted by B.Goode — Thu Jul 31, 2025 8:43 pm