hello, newbie here.
I have been attempting to get an LED to blink that I have connect to a breadboard and the pico. I have replaced everything I can but the pico itself. The LED is not backwards and everything is grounded. The code even works on wokwi without any issues
here is the code I have:here is my setup:here is wokwi setup:Notes: I was able to upload the blinky uf2 file and have the onboard LED blink. But when I upload my uf2, nothing happens. Something else I notice happening is when i upload my file, unplug the pico, and then plug it back in without holding bootsel, the onboard LED starting blinking. I can only assume that is because of the blinky file, but I don't understand how that is happening if I am uploading a new file?
To compile, i am doing "cmake .." "make"
any help appreciated
I have been attempting to get an LED to blink that I have connect to a breadboard and the pico. I have replaced everything I can but the pico itself. The LED is not backwards and everything is grounded. The code even works on wokwi without any issues
here is the code I have:
To compile, i am doing "cmake .." "make"
any help appreciated
Statistics: Posted by fiddlefig — Sun Aug 03, 2025 8:14 pm