Troubleshooting • Re: another undervolted argon one

The installation instructions for the Argon ONE V3 do state you need to add the following to /boot/firmware/config.txt

Code:

usb_max_current_enable=1

This is due to the power going through the Argon board, do the Pi cannot negotiate. This is no problem, and my pi5 has worked like this for ages

that will tell the pi to allow more current to be drawn on the usb ports
but it doesnt do jack for increasing the stability of the 5v rail

if your actually getting undervoltage events, letting it draw more current will only make it worse

Statistics: Posted by cleverca22 — Sun Sep 14, 2025 8:57 pm

---