Hello Everyone,
I'm trying to use Trixie on My PI Zero 2W and everything is fine during boot but at some point the HDMI Signal drops and I can't bring it back.
I've tried two different SD Cards one I use customised setting the other I left it stock.
I wanted to run headless but it seemed like the setting didn't take I figured I did something wrong but I couldn't access the system without a display. I then flashed a new card with no settings and again I saw boot messages then after a point the screen goes blank and no signal. I used a PI 5 running Bookworm and Raspberry Pi imager V1.9.4 The OS flashed was Trixie Lite 32bit. I saw a message that There is a newer version of imager but when I checked with APT the latest is installed.
Anything I can do to savage this?
The keyboard works on the Pi zero 2 w I can ctrl alt del and reboot this brings up the boot text again for awhile
I'm trying to use Trixie on My PI Zero 2W and everything is fine during boot but at some point the HDMI Signal drops and I can't bring it back.
I've tried two different SD Cards one I use customised setting the other I left it stock.
I wanted to run headless but it seemed like the setting didn't take I figured I did something wrong but I couldn't access the system without a display. I then flashed a new card with no settings and again I saw boot messages then after a point the screen goes blank and no signal. I used a PI 5 running Bookworm and Raspberry Pi imager V1.9.4 The OS flashed was Trixie Lite 32bit. I saw a message that There is a newer version of imager but when I checked with APT the latest is installed.
Anything I can do to savage this?
The keyboard works on the Pi zero 2 w I can ctrl alt del and reboot this brings up the boot text again for awhile
Statistics: Posted by DarkElvenAngel — Sun Nov 09, 2025 1:19 am